The system is supplied in two parts: Cup sensor (+) Control electronics.
The cup sensor must be installed vertically and free of obstacles.
The control electronics must be installed inside an existing electrical panel (DIN rail mounting).

Using the 4 front push-buttons on the control electronics, you can program the 2 trigger relays in a maximum of 5 minutes.
In addition to the trigger value in km/h, you can set a delay to ignore momentary wind gusts.

Yes. Our control electronics feature a display that shows real-time wind speed.

It can be applied to any equipment or environment where excessive wind can cause serious accidents, such as:
• Gantry cranes and Overhead cranes;
• Telescopic cranes or Hoists (complies with NR18 construction standards);
• Lifting equipment (complies with NR12 safety at work standards);
• Ports, ships, marinas;
• Mineral yards;
• Wind farms;
• Airports;
• Storage silos;
• Tunnels, highways, railways.

• Low acquisition cost compared to competitors;
• Permanent stock for immediate delivery;
• Quick and simple programming of limit relay triggers;
• 4-20mA output included in the standard version at no additional cost.